Information presented on this website is for informational purposes only, and is not legal advice. You agree that you will be solely responsible for your decision to purchase CBDfx™ products and determining compliance with the local rules or regulations in your applicable jurisdiction. ***CBDfx products that are marketed as ND-THC (non-detectable) may contain trace amounts of THC that nearly undetectable by scientific laboratory testing standards.ĬBDfx™ assumes no responsibility for and expressly disclaims all legal issues resulting from your purchase or use of the CBDfx™ products. These products are not intended to diagnose, treat, cure or prevent any disease. The efficacy of these products has not been confirmed by FDA-approved research. If I need to provide any additional info I’ll be happy to do so, just let me know what.**FDA Disclaimer - The statements made regarding these products have not been evaluated by I’ve emailed Makebox but no response yet.Īny ideas what I’m doing wrong or what I need to do for it to work? I really like the features of LightBurn and want to purchase it but unless I can get it to work with my xTool D1 I’ll be unable to do so. The xTool D1 still works fine with the Laserbox Basic software. When I click the Start button it doesn’t do any thing except give me an error message “There was a problem sending data to the laser. When I click the Frame button it doesn’t move at all. When I start LightBurn my xTool D1 indicates that it is connected and ready but the xTool D1 doesn’t respond at all. Installed xTool’s device driver “xTool-D1-V2.lbdev”. Set the program up following xTool’s instructions. Yesterday I downloaded and installed the 30 day trial of LightBurn (Version 1.1.04). I’ve ran a few projects using Laserbox Basic and everything works great but their program is just too limiting. Performed update check on Software and Firmware and was notified I have the latest version of both. I downloaded and installed Laserbox Basic from xTool’s website.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |